Kathrein DVB-S-UKW Manual De Instrucciones página 10

Octal 1
Ra SWR 4 BW
Outp.
RDS edit
The parameter "Channel name" shows the channels available on the transponder. The channels are selected using the up/down buttons.
The language of the listed channel is shown to the right of the channel name.
If "Acquisition" or "Read SI data" appears here, the channel unit is not currently available for input. Wait until the channel names are
displayed.
2.3 Setting the output signal of the selected FM channel
Octal 1
Ra SWR 4 BW
Outp.
RDS edit
Use the cursor keys to select the parameter "Output frequency". The up/down keys allow the output frequency to be set in 50 kHz steps.
The output frequency can also be changed by numeric input.
*** UFO
Level
Output
Audio
When the " " button is pressed, the parameter "output frequency" appears in a submenu for activation/deactivation of the selected
FM output and for setting the output level. If "Off" is selected for the output, this channel is switched off and no longer appears in
the output spectrum.
Setting the output level in the range "max, -1 to -39, min" allows the selected channel output to the reduced by up to -20 dB.
Note: The output level for FM signals is usually set 4 dB lower than that for PAL-TV signals.
Note: Under some circumstances, distortion may occur in the frequency range 98-108 MHz at maximum output signal
volume. We therefore recommend that in this frequency range at least two output signals should be set and where
necessary the level should be reduced by 2 dB.
*** UFO 313 -
Level
Output
Audio
Here the mode "Auto, 2-sound-B, mono, stereo" can be set. "Auto" automatically adapts to suit the transmission of the source.
If a TV audio carrier is being transmitted it may be necessary to select then channel with 2-sound A or B. Pressing the " " button takes
you back to the previous display in the main menu.
E1
ger
87.50 MHz
Vol 0dB
E1
ger
87.50 MHz
Vol 0dB
313 - Octal 1 ***
max
On
Auto
Octal 1 ***
max
On
Auto
4 / 6