PANCONTROL PAN 124 Manual De Instrucciones página 28

1. Always adjust the rotary switch to the desired measuring range before
starting the measurement and engage the switch in the proper measuring
range. If the magnitude of the signal to be measured is not known, always
start with the highest measuring range on the rotary switch and then reduce
step-by-step.( 2A / 20 A / 200 A / 400 A).
2. Press the lever to open the induction jaw.
3. Close the jaw and place the conductor centered between the induction
clamps.
4. Once the reading stabilizes, read the value. If the polarity is twisted a "Minus
sign" is displayed. Use the HOLD function if the reading is difficult to read.
Resistance measurement / Continuity test
Use the provided test leads to perform these measurements.
Attention: Before making any measurements, make sure the circuit is
disconnected from any power source and all capacitors are properly
discharged!
1. Set the rotary switch to the  - Position.
2. Attach the pin-plug of the black test lead to the COM-jack and the pin-plug of
the red test lead to the V-, A-, Ω-jack.
3. Connect the test prods of the leads to the resistance or circuit to be tested. To
avoid influence disconnect the resistant to be tested from the circuit.
WRONG RIGHT
EN 11