Introduction; Parts List; Tools Required; Important Safety Instructions - Tripp-Lite SmartRack SRCABLELADDER Manual Del Propietário

1 – Introduction
SRCABLELADDER provides roof-mounted cable routing for Tripp Lite's SmartRack Enclosures, allowing cable bundles to span aisles and/or
spaces between enclosures in the same row. Note: Standard installation of SRCABLELADDER requires Tripp Lite's SRCABLETRAY accessory,
sold separately.

1-1 Parts List

A Ladder Sections (2)
B Assembly Brackets (4)
C Clevis Pins (8)
Cotter Pins (8)
D
E Ground Brackets (2)
F M6 Hex-Head Bolts (2)
G 24-inch Ground Cables (3)
H M6 Lock Washers (4)
I M6 Hex Nuts (2)
J Ladder Clamp (4)
K M10x60 mm Carriage Bolts (2)
L M10 Lock Washers (2)
M M10 Hex Nuts (2)
If any parts are missing, visit www.tripplite.com/support.

1-2 Tools Required

• 13 mm Wrench or Crescent Wrench
• Tape Measure
• Hacksaw (optional)
• Drill with 3/8-inch Bit (optional)
2 – Important Safety Instructions
SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that must be followed during the installation and operation of the product described in this
manual. Read all instructions and warnings thoroughly before attempting installation. Failure to comply may invalidate the warranty and
cause property damage and/or personal injury.
• Install in a controlled indoor environment, away from moisture, temperature extremes, flammable liquids and gasses, conductive
contaminants, dust and direct sunlight.
• Provide suitable grounding in accordance with all applicable electrical wiring regulations.
• Do not attempt to climb or walk across any part of the ladder.
• When using tools to cut or drill metal, use eye protection and follow all other safety precautions recommended by the tool manufacturer and
required by applicable safety regulations.
• Use caution and wear safety gloves when handling metal parts that have been cut to length. Sharp edges can cause personal injury and
property damage.
• Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the failure of the life
support equipment or to significantly affect its safety or effectiveness is not recommended. Do not use this equipment in the presence of a
flammable anesthetic mixture with air, oxygen or nitrous oxide.
201105211 93-2973.indb 2
A
B
C
J K
2
D
E
F
L
G
H
I
M
5/23/2011 12:56:45 PM