Ground Connection - Tripp-Lite SmartRack SRCABLELADDER Manual Del Propietário

3 – Installation
3-5 Installation Within Row
6 After inserting the clevis pins, insert a cotter pin
hole at the end of each clevis pin. (The straight section of the
cotter pin goes through the hole.)

3-6 Ground Connection

After installing the SRCABLELADDER accessory, determine
1
where to place ground brackets by noting the distance between
one end of the ladder and the grounding post
nearest SRCABLETRAY accessory.
2 Place a ground bracket
accessory's leg and use a hex-head bolt
3
Use the included hex nuts and lock washers
of the included ground cable
of the nearest SRCABLETRAY accessory and connect the other
end to the grounding post
SRCABLELADDER accessory. Repeat steps 1 to 3 for the other
end of the SRCABLELADDER accessory.
201105211 93-2973.indb 7
(continued)
(continued)
through the
G
at the corner of the
A
near the end of the SRCABLELADDER
B
to secure it.
C
to connect one end
G
to a grounding post at the corner
H I
of the ground bracket attached to the
J
G
6
A
1
2
G
I
3
7
B
C
J
G
H
5/23/2011 12:56:48 PM