Uline H-1586 Guia De Inicio Rapido

π
H-1586, H-1587
POLY CORD STRAPPING
TENSIONERS
Cutter Wheel
Windlass
1. Slide strap through buckle as shown. (See Figure 1)
Figure 1
2. Put strap and buckle around package and
manually tighten the strap. (See Figure 2)
Figure 2
3. Take the tensioner by the right hand and depress
tension lever. Place strap under the gripper so that
it touches the housing with the right hand edge.
Release tension lever. (See Figure 3)
Figure 3
π
PAGE 1 OF 3 CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com
Tension Lever
Base Handle
Gripper Plate
OPERATION
4. Insert upper strap into slot of cutter mechanism and
the windlass. Hold tool and strap with your left hand
and move the tension lever forward and backward
until the strap is tensioned. (See Figure 4)
Figure 4
5. Depress the tension lever completely until the strap
is cut. Pivot the tensioner away from the strap.
(See Figure 5)
Figure 5
Para Español, vea página 2.
Pour le français, consulter la page 3.
Tension Lever
Windlass
Cutter
1014 IH-1586