Service Notes - Revell Control Rayvore Manual De Instrucciones

ATTENTION!
Flying model aircraft and helicopters outdoors has required mandatory liability
insurance since 2005. Contact your private liability insurer and make sure that your
new and earlier models are included in your insurance coverage. Request written
confirmation and keep this in a safe place. Alternatively, the DMFV offers a trial
membership free of charge online at www.dmfv.aero, which includes insurance.
9 CalIBraTIoN
If the quadrocopter drifts or if trimming is difficult while flying (yawing), you can try
calibrating your quadrocopter.
1. Switch the remote control on and set all trims to neutral (the remote control beeps
when one of the trim buttons is pressed). The tone becomes higher as the trim is
moved away from the neutral point and lower as it gets closer to the neutral point.
The neutral point itself is indicated with a longer, low tone).
2. Now switch on the quadrocopter, place it on a level surface and wait until it has
connected with the remote control.
3. Set the left stick to zero and press and hold the right stick.
4. Press the left stick briefly three times. Then release everything and press the thrust
trim upwards, the red status LED on the rear of the quadrocopter flashes slowly.
5. When the red status LED on the rear of the quadrocopter is lit continuously again,
the calibration is complete. Now press the left stick to save the settings.
10 ChaNgINg The propellerS
If the rotor blades of the Quadrocopter are damaged, they must be replaced.
Proceed as follows:
Prior to installation, make sure that you do not mix up the propellers. The Quadrocopter has
4 different propellers, which differ in colour and direction of rotation. If the propellers
are mixed up, the Quadrocopter will not fly.
10A Screw the locking screw of the propeller counter-clockwise from the propeller and
carefully pull the defective propeller from the shaft.
10B Carefully fit the new propeller on the shaft and carefully screw the securing screw
on again in a clockwise motion.
10C Figure 10C shows a top view of the Quadrocopter. The propellers are marked
with little arrows indicating the direction of rotation. Please assemble as follows:
front left colored clockwise
back left black counter-clockwise
Flight direction: The colored propellers are at the front.
20 20
front right colored counter-clockwise
back right black clockwise
TroUBleShooTINg
Problem: The quadrocopter does not react to control commands.
Remedy: Charge or replace the battery of the quadcopter. Switch the remote
control and the model off and on again (see 5. PREPARING FOR TAKE-OFF).
Problem: Red LED is flashing on the remote control.
Remedy: Replace the AAA batteries in the remote control.
Problem: The model will no longer fly loops.
Remedy: The battery charge level is too low.
Problem: The model will not remain level in the air.
Remedy: Battery power is too low - charge the battery! Turn the model and the
remote control off and on again. Land, wait 3 seconds and start again.
Problem: The model does not take off.
Remedy: Propellers are not mounted correctly. Observe chapter 9 "Changing the
propellers".
Problem: The model flounders in the air.
Remedy: Check the cabin cover, the motors and the propellers for damage.
Problem: The quadrocopter does not start.
Remedy: The battery is empty - charge the battery! Observe the following se-
quence when switching on: switch on the remote control first, then the
quadrocopter!
Additional tips and tricks can be found online at www.revell-control.de.

SerVICe NoTeS

Go to www.revell-control.de for ordering information
and tips on replacing spare parts, plus other useful
information on all Revell Control models.
www.revell-control.de
21