Battery Status; Service Notes - Revell Control NANO POCKET XS Manual Del Usuario

INSTRUCTIONS FOR SAFE FLYING
GENERAL FLYING TIPS:
• Always place the model on a level surface. An inclined surface can,
under certain circumstances, have a negative impact on the starting
behavior of the model.
• Always operate the controls slowly and with a gentle touch.
• Always maintain visual contact with the model and do not look at the
remote control!
• Move the thrust control down again somewhat as soon as the model
lifts off from the ground. Maintain flying altitude by adjusting the thrust
controller.
• If the model lowers, move the thrust control slightly upward again.
• If the model climbs, move the thrust control down slightly.
• To fly along a curve, tapping the directional controller very slightly in the
respective direction often suffices.
There is a general tendency during preliminary attempts at flight to
operate the model's controls too aggressively.Always operate the
controls slowly and carefully. Never fast and fitfully.
• Beginners should first master trimming before attempting to master the
thrust controller. The model does not necessarily have to fly straight at
the beginning - initially, it is more important to maintain a constant
height of approximately one meter above the ground by repeatedly
tapping the thrust control. Only then should the pilot practice steering
the model left and right.

BATTERY STATUS:

• The battery is empty if the model begins to lose thrust. Land in order to
avoid crashing.
9 CHANGING THE PROPELLERS
If the rotor blades on the model are damaged, they must be
replaced. Pay attention to the direction of rotation of the propellers.
The marking A and B are found on the upper side of the propeller at
the hub. To do so, proceed as follows:
9A Hold the faulty rotor blade with two fingers and pull it off carefully
to the top.
9B Place the new rotor blade on the shaft and press it carefully
in place.
Additional tips and tricks can be found online at
www.revell-control.de.
26 26
TROUBLESHOOTING
Problem: The propellers do not move.
Cause: • No connection has been established.
• The battery is too weak or depleted.
Remedy: • Switch everything off and switch on again in the
correct sequence.
• Charge the battery.
Problem: The model stops and descends during flight for no
apparent reason.
Cause: • The battery is too weak.
Remedy: • Charge the battery.
Problem: The model cannot be controlled with the remote
control.
Cause: • The ON/OFF switch is in the „OFF" position.
• The batteries were not inserted correctly.
• The batteries do not have enough power.
Remedy: • Set the ON/OFF switch to the „ON" position.
• Check whether the batteries are inserted correctly.
• Insert new batteries
Problem: The model only turns on its vertical axis or rolls
over when started.
Cause: • Incorrect arrangement of the propellers.
Remedy: • Install the propellers and arms as outlined in the
manual.
Problem: The model will no longer fly loops.
Cause: • Battery too weak.
Remedy:
• Charge the battery.

SERVICE NOTES

Go to www.revell-control.de for ordering
information and tips on replacing spare
parts, plus other useful information on all
Revell Control models.
www.revell-control.de
27 27