Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
37 - MENU RESET
IMPORTANT! After learning the path and torque, the control unit records infor-
mation about the mains voltage of the place where it was installed and does
not allow it to be installed in another voltage mains (LED flashes 5 times when
connected to the mains).
If it is necessary to change the voltage or network from which the control unit
recorded the trip, reset the path as shown below, remove the control board from
the mains and wait for a few seconds and then turn it on again.
Important: Each time the switch is reset, it will do the learning again.
In this mode it is possible to reset all settings of the control panel or only the
path, the controls are not deleted in this mode *.
To execute the command, set the PROG switch to the position as shown in the
figure below. Define which command you want to execute according to the tab-
le below, view the number of times the LED flashes, press the LEARN button if
you need to increase the number of times the LED flashes. After the procedure,
return the DIP switches to their original position.
IMPORTANTE!!! Antes de pressionar o botão LEARN, observe com atenção a tabela abaixo,
pois uma vez que você chegar na quantidade de vezes em que o LED pisca, a central executa o
comando indicado na tabela abaixo.
PROG SWITCH POSITION
RESET PATH
38 - ERROR TABLE
After an error occurs, the LED (red) will flash for the error code.
78
NETWORK ERROR (VOLTAGE)
1 vez
-
4 vezes
MENU RESET
LED PISCA
2 vezes
-
5 vezes
RESET TOTAL*
INGLÊS
PROGRAMMING
SETTING RESET
3 vezes
-
6 vezes
-
Publicidad
Tabla de contenido
