Maintenance
!
Always switch off the electricity supply before
carrying out any cleaning or servicing operations on
the appliance.
!
To avoid possible risks of fire always comply with
the indicated instructions when cleaning grease
filters and when removing grease deposits from the
appliance.
Careful maintenance will assure good functioning and
good efficiency over time.
Cleaning the hood
Any fat deposits should be removed from the appliance
periodically depending on amount of use (at least every
2 months). Avoid using abrasive or corrosive products.
To clean painted appliances on the outside, use a cloth
dipped in lukewarm water and neutral detergent. To
clean steel, copper or brass appliances on the outside,
it is always best to use specific products, following the
instructions on the products themselves. To clean the
inside of the appliance, use a cloth (or brush) dipped in
denatured ethyl alcohol.
Cleaning the grease filters
Special attention must be given to the grease filters
which must be periodically cleaned, whenever the
grease filter alarm trips. For instructions of the filter
Alarm, refer to the Controls paragraph.
Wash the filters by hand or in the dishwasher using
a neutral detergent. If they are washed in the
dishwasher, any loss of colour will not jeopardise
functioning of the filters in any way.
Removing the grease filters:
remove the metal panels; to remove the grease filters,
push the catch near the handle towards the inside and
pull the filter downwards.
Replacing the charcoal filter
If using the hood in filtering version, the charcoal filters
will have to be replaced periodically when the charcoal
filter alarm appears. For instructions on the filter alarm
refer to the paragraph Controls.
Removing the charcoal filter:
Remove the metal panels. Remove the grease filters
by pushing the catch and turning the filters outwards.
Then remove the charcoal filter. Push the catch towards
the inside and turn the filter so that the 2 filter clips slip
out of their seats.
Replacing the lamps
Open the Halogen Bulb hatch by pushing it on one
side (on the writing "PUSH") and then release. Replace
the bulbs with other bulbs of the same kind.
WARNING: Do not touch the new lamp with bare
hands.
GB
15