Safety Strap - Sauder Harbor View Serie Manual Del Usuario

Step 12
Lay the SMALL BACK (Q) over your unit.
å
A perforation in the SMALL BACK (Q) has been provided for
å
access to the SAFETY STRAP (60M). Punch out the perforation
and push the SAFETY STRAP through the hole.
Line up the top edge of the SMALL BACK (Q) with the top edge
å
of the TOP. Then, make equal margins along the short edges of
the SMALL BACK (Q). Push on opposite corners of your unit if
needed to make it "square".
Fasten the SMALL BACK (Q) to your unit using the NAILS (1N).
å
Unfold the LARGE BACK (R) and lay it over your unit.
å
NOTE: The LARGE BACK will overlap the SMALL BACK.
å
Line up the bottom edge of the LARGE BACK (R) with the
å
bottom edge of the BOTTOM. Then, make equal margins along
the long edges of the LARGE BACK (R). Push on opposite
corners of your unit if needed to make it "square".
Fasten the LARGE BACK (R) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that
å
line up over the SHELF (L).
These holes must line
up over the SHELF (L).
Page 16
These holes must line up
over the UPPER SHELF (J).
R
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
60M
Q
423661
1N
NAIL
(72 used for the BACKS)
Before fastening the
BACK, punch out the
perforation and push
the SAFETY STRAP
through the hole.
Q
R
The LARGE BACK (R)
will overlap the
SMALL BACK (Q).
www.sauder.com/services