HoMedics BPA-260 Manual De Instrucciones página 23

2. With the cuff wrapped around your arm, press the
START/STOP button. Do not inflate the cuff unless it is
wrapped around your arm. All digits will light up to check
the display functions. The checking procedure will be
completed after about 3 seconds.
Note: If using the Voice Assist
3. After all symbols disappear, the display will show
"00". The monitor is "Ready to Measure" and will
automatically inflate the cuff to start measurement.
4. The cuff will begin deflating as measurement continues.
Note: This monitor will re-inflate automatically if the
BPA-260_A 323101305 0623.indd 22
you will be prompted to press the START/STOP
button again before measurement begins.
system detects that your body requires more
pressure for measurement.
®
"Instructions On" mode,
22
2010/6/23 下午 10:05