OPERATING INSTRUCTIONS
POST-START CHECKLIST (ENGINE RUNNING)
1.
Check main and side brooms to make sure they are free of debris which will inhibit rotation & pick-up.
NOTE: Always wear hand protection when cleaning debris from brooms and/or brushes.
2.
Check squeegees to make sure there is no damage and they meet the fl oor.
TO TRANSPORT MACHINE (NO SCRUBBING OR SWEEPING)
1.
Be sure the brooms, brushes (scrub deck) and squeegee are in the "Up" position with all other controls in the "Off" position.
2.
Release parking brake.
3.
Push throttle control up.
4.
Push forward on the directional control pedal to place the machine in motion.
5.
Vary your foot pressure on the directional control pedal to obtain desired travel speed.
6.
To stop, allow directional control pedal to return to neutral (centered) position. (Pedal will automatically return to neutral when foot pressure is
released). FOR NORMAL OPERATION, DEPRESS DIRECTIONAL CONTROL PEDAL WITH HEEL INTO NEUTRAL.
7.
Push engine throttle down. Turn key to "Off".
8.
Set parking brake.
TO BEGIN THE CLEANING OPERATION
1.
Choose the mode of operation (recycling ESP or non-recycling STANDARD) as dictated by the machine fi ll or machine type.
2.
Bring engine to full RPM.
3.
Lower the main broom.
4.
Lower the side broom.
5.
Turn on the main and side brooms.
6.
Sweep for the length of the machine.
7.
Move recovery switch to the "On" position.
8.
Lower the scrub brushes.
9.
Lower squeegee to the "Lower" position.
10. Move solution control lever to the desired setting.
11. Turn on the Recovery Switch for the ESP Recycling system, if applicable.
12. Begin scrubbing operation.
Single sweep and scrub the average fl oor with light to medium soil. In this operation the cleaning is accomplished in one pass with simultaneous
solution feed, sweeping, scrubbing and dirty water pick-up. The rate of solution feed and the speed of travel required will vary with fl oor condition.
This knowledge will come with operator experience.
ENGLISH / A-21
FORM NO. - 56041801 - 7765 - A-21