A-22 / ENGLISH
OPERATING INSTRUCTIONS
HELPFUL HINTS FOR CLEANING OPERATION
Do not turn the steering wheel sharply when the machine is in motion. The sweeper is very
responsive to movement of the steering wheel. Do not make sudden turns.
Scrub in straight paths. Do not bump posts. Do not scrape the sides of the machine.
When the machine is in motion, do not push the directional/speed control pedal all the way forward. This is the
same as starting in "High" and will put a strain on the motor and drive system.
1.
Plan your sweeping and scrubbing in advance. Try to arrange long runs with minimum stopping and starting.
Sweep debris from narrow aisles out into main aisle ahead of time. Do an entire fl oor, or section at one time.
2.
Pick up oversize debris before sweeping.
3.
Allow a few inches overlap of sweep and scrub paths. This will eliminate leaving dirty patches.
4.
Don't turn steering wheel too sharply when machine is in motion. The machine is very responsive to movement of the steering wheel - so
avoid sudden turns.
5.
Try to follow as straight a path as possible. Avoid bumping into posts or scraping the sides of the machine.
6.
When placing the machine in motion, avoid slamming the directional control pedal all the way forward quickly. This is equivalent to starting out
in "HIGH" and puts needless strain on the engine and drive system.
7.
Always allow the machine to warm up before operating in cold temperatures.
8.
Periodically turn sweeping (main) broom end for end to prevent the bristles from "setting" in one direction.
Replace sweeping broom when bristles are worn to 3-inch (8-cm.) length. Replace disc brushes when bristles
are reduced to 1/2 inch (1.3 cm) in length. Replace squeegee blades when all usable edges have become
A-22 - FORM NO. - 56041801 - 7765
SIDE AISLES
MAIN AISLE
SIDE AISLES
FIGURE 18
WARNING
NOTE
rounded with wear, impairing the wiping action.