Kohler K-99003-TLC Guía De Instalación Y Cuidado página 11

7. Surface-Mount – Secure the Cabinet
NOTE: The following instructions are for surface-mount only. For recess-mount installation, refer to the
"Recess-Mount" sections.
Slide a clip onto each end of the top T-slot.
Center the cabinet on the wall as desired.
Using a 3/32" drill bit, drill pilot holes into the wall.
If anchors are needed, remove the cabinet and install anchors into the wall at the pilot hole
locations.
Secure the clips with 1-1/2" screws (provided).
Slide two clips onto the bottom T-slot.
Position each clip 2" (51 mm) from the ends of the cabinet.
Using a 3/32" drill bit, drill pilot holes into the wall.
If anchors are needed, remove the cabinet and install anchors into the wall at the pilot hole
locations.
Secure the clips with 1-1/2" screws (provided).
Kohler Co.
3/32"
2" (51 mm)
11
3/32"
1267931-2-H