Abicor Binzel FCAW Instructivo De Servicio página 31

12 Disposal
12 Disposal
12.1 Materials
12.2 Consumables
12.3 Packaging
EN - 16
NOTICE
• Observe the information given in section 8 Putting out of operation on
page EN-11.
1 Disconnect the cable assembly from the wire feeder.
2 Remove the parts to be disconnected (protective shield, mount, torch neck).
For disposal, the local regulations, laws, provisions, standards and guidelines
must be observed. For the product to be properly disposed of, it first must be
dismounted.
 See 11 Dismounting on page EN-15
This product is mainly made of metallic materials which can be molten in steel
and iron works and are thus almost infinitely recyclable. The plastic materials
used are marked in preparation for sorting and separation of the materials for
later recycling.
Oils, greases and cleaning agents must not contaminate the ground and not
enter sewage systems. These materials must be stored, transported and
disposed of in suitable containers. Please observe the relevant local regulations
and disposal instructions of the safety data sheets given by the manufacturer of
the consumables. Contaminated cleaning tools (brushes, rags, etc.) must also
be disposed of in accordance with the information provided by the
manufacturer of the consumables.
ABICOR BINZEL has reduced the packaging for shipping to a minimum.
Packaging materials are always selected with regard to their possible recycling
ability.
ALPHA FLUX