Mounting The Liner - Abicor Binzel FCAW Instructivo De Servicio

ALPHA FLUX

6.3 Mounting the liner

1
9
1 Torch neck
2 Protective shield
3
Handle
Fig. 3 Mounting the liner
2
4 Central connector KZ-2
5 Liner
6
Support sleeve AF 11
NOTICE
• New still unused liners have to be shortened to the actual length of the
cable assembly.
1 Lay down the cable assembly straight.
2 Unscrew retaining sleeve (6) / clamping screw (7).
3 Insert the new liner (5).
4 Measure the excess length of the liner:
• subtract 15 mm in case of a central connection
• add 1 mm in case of a Lincoln connection
5 Pull out liner (5).
6 Shorten the front side of the liner by the calculated length
7 Debur the edge
8 Insert the liner (5).
9 Tighten retaining sleeve (6) / clamping screw (7).
6 Putting into operation
15
1
8
7 Clamping screw AF 8
8 LN connection
9
Coaxial cable
3
4
5
6
7
EN - 9