Troubleshooting - Fellowes Lyra 3-in-1 Binding Center Manual De Instrucciones

REMOVAL OF WASTE CLIPPINGS
STORAGE

TROUBLESHOOTING

BINDING
Problem
Punched holes are not central
Machine will not punch
Punch holes are not parallel to edge
Partial holes
Damaged hole edges
3-HOLE PUNCHING
Problem
Incomplete punches
Holes not aligned to edge of paper
Holes not centered on paper
STAPLER
Problem
Stapler jam
Staple too close to edge of paper
Stapler depth guide moves when
setting paper
LIMITED WARRANTY
Cause
Sheets not correctly aligned to punch pattern
Possibly overloading the machine
Cause
Waste tray too full
Paper chads still in punches
Paper not set up properly
Cause
Stapler release button not pressed
Stapler depth guide not set correctly
Pushing too hard on guide
Solution
Adjust edge guide to correct paper or cover size.
sideways to release any stray clippings into the waste tray
Adjust edge guide and test punch scrap sheets until correct
punched
Solution
Move paper side to side in the throat to remove paper debris
Align paper to the left side of the punch throat prior to punching
Solution
Use pencil to pop open stapler mechanism to clear jam
Press stapler release button
Adjust stapler depth guide to desired position
position
-
-
5