Troubleshooting; Need Help - Fellowes Pulsar e 300 Manual Del Usuario

CORRECTING A BOUND DOCUMENT
Additional sheets may be include or removed at any time by opening and then closing the comb as previously described.
REMOVAL OF WASTE CLIPPINGS
The waste tray is located under the machine and is accessed from the right side. For best results empty the tray regularly.
STORAGE
Switch off the machine. Lower the lid. The Pulsar-E comb binder is designed to be stored horizontally on the desk.

TROUBLESHOOTING

Problem
No Green power light
Red standby light
Punched holes are not central
Machine will not punch
Punch holes are not parallel to edge
Waste tray leaks
Partial holes
Damaged hole edges
Waste tray leaks
WARRANTY
Fellowes warrants all parts of the binder to be free of defects in material and workmanship for
2 years from the date of purchase by the original consumer. If any part is found to be defective
during warranty period, your sole and exclusive remedy will be repair or replacement, at
Fellowes' option and expense, of the defective part. This warranty does not apply in cases of
abuse, mishandling or unauthorised repair. Any implied warranty, including that of merchant-
ability or fitness for particular purpose, is hereby limited in duration to the appropriate warranty
Cause
Machine is not switched on
Machine is overloaded when punching
Edge guide not set
Blockage
Debris is stuck below dies
Waste tray is not correctly inserted or 'burst feature' has activated
Sheets not correctly aligned to punch pattern
Possibly overloading the machine
Waste tray is not correctly inserted or 'burst feature' has activated
Solution
Switch on machine at rear next to plug inlet and at the socket
Press the punch button. The machine will withdraw the punches and re-set
itself. Continue this process until the punch cycle is complete
Adjust edge guide to correct paper or cover size
Check waste tray is empty. Check for blockage to paper entry
Take stiff cardboard and slide into the paper entry. Move the cardboard
sideways to release any stray clippings into the waste tray
Check waste tray is empty and 'burst feature' is closed
Adjust edge guide and test punch scrap sheets until correct
Punch plastic covers with paper sheets. Reduce number of sheets being
punched
Check waste tray is empty and 'burst feature' is closed

Need Help?

Let our experts help you
your place of purchase.
period set forth above. In no event shall Fellowes be liable for any consequential damages
attributable to this product. This warranty gives you specific legal rights. You may have other
legal rights that vary from this warranty. The duration, terms and conditions of this warranty are
valid worldwide, except where different limitations, restrictions or conditions may be required by
local law. For more details or to obtain services under this warranty, please contact Fellowes or
your dealer.
Customer Service....
www.fellowes.com
with a solution.
Always call Fellowes
before contacting
5