Performance 23393265 Manual Del Usuario página 10

Part 6: Rear Coil Spring Installation:
1. Rear Coil Spring Lower Insulator (2) » Install
2. Rear Coil Spring Insulator (3) » Install
3. Rear Coil Spring (1) » Install
4. Raise the rear suspension lower control arm (1) back into position.
Caution: This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener
when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or
component.
5. Rear Suspension Lower Control Arm Bolt (2) » Install
Install a NEW bolt.
6. Rear Suspension Lower Control Arm Nut (1) » Install
Tighten
1. First Pass: 160 Nm (118 lb ft)
2. Final Pass: (90–105 degrees)
Suspension Lowering Kit
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
23393265
IR 19NO15
PART NO.
DATE
19NO15 Initial Release - Daniel Parrino
10
SHEET
REVISION
36
OF
AUTH
2204871