Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
8. Remove the front suspension strut assembly (1) from the vehicle.
9. Transfer components as necessary.
Part 3: Spring Replacement:
Warning: To prevent personal injury and/or component damage, use the proper tools to support and compress the coil spring
prior to removal of the strut shaft nut when removing the coil spring. The coil spring is under extreme pressure and can become a
projectile should the spring separate from the strut before all of the tension is relieved.
Preliminary Procedure
Front Strut Rod Mount Nut
Procedure
1. Use the CH-48845 compressor to compress the front coil spring.
2. Use the CH-49375 wrench to remove and install the front strut rod mount nut
1
Tighten
70 Nm (52 lb ft)
Special Tools
CH-48845 Strut Spring Compressor
CH-49375 Strut Spring Wrench
2
Front Suspension Strut Mount
3
Front Coil Spring Upper Insulator
4
Front Coil Spring
5
Front Suspension Strut Bumper
6
Front Strut Boot
7
Front Coil Spring Lower Insulator
8
Front Suspension Strut
Suspension Lowering Kit
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
Strut, Strut Component, or Spring Replacement
IR 19NO15
DATE
19NO15
23393265
PART NO.
REVISION
Initial Release - Daniel Parrino
5
36
SHEET
OF
AUTH
2204871
Publicidad
Tabla de contenido
