Pre-Installation; Planning Installation; Tools Required; Hardware Required - Husky HDC302000 Guía De Uso Y Cuidado

Pre-Installation

PLANNING INSTALLATION

It is extremely important to use the compressor in a clean,
well ventilated area where the surrounding air temperature
will not be more than 100°F. Provide a minimum clearance
of 18 in. between the compressor flywheel or fan and the
wall, and ensure clear access to the drain valve to facilitate
condensate drainage. Do not locate the compressor air inlet
near steam, paint spray, sandblast areas, or any other source
of contamination.

TOOLS REQUIRED

Ratchet and
1/2 in. Socket
9/16 in. Socket

HARDWARE INCLUDED

Part Description
AA Isolater Foot bolt
BB Locknut - 5/16 - 18 Spinlock Nut Bolt
CC Coupler - 1/4 in. I/M Steel Coupler
NOTE: Hardware not shown to actual size.
Safety Goggles
AA
IMPORTANT: This compressor is not intended for
outdoor installation.
Work Gloves
BB
6
Adjustable
Wrench
CC
Quantity
2
2
1