Tripp-Lite B127A-1A1-BHBH Manual Del Propietário página 14

Standard Extender Kit Installation
1.
2.
3.
4.
5.
6.
7.
-10-008-933D27-Book.indb 14 -10-008-933D27-Book.indb 14
Make sure all equipment in the installation—such as TVs,
Blu-ray players and the transmitter—is powered OFF.
Using an HDMI 2.0 cable (such as Tripp Lite P569-XXX-CERT
or P568-XXX-2A Series cables), connect the HDMI source to
the INPUT port on the local transmitter unit.
Optional for B127A-1A1-BHPH: Using an HDMI 2.0 cable
(such as Tripp Lite P569-XXX-CERT or P568-XXX-2A Series
cables), connect a local monitor to the LOCALOUT port on
the B127A-1A1-BHPH local transmitter unit.
Optional: For extended range, connect a B127A-010-H
signal repeater unit to the transmitter and receiver via
Cat6 cabling. See B127A-010-H product features for
more information.
Using Cat6 cable, connect the RJ45 port on the local
transmitter unit to the RJ45 port on the remote receiver unit.
Connect the remote receiver unit's HDMI cable to a monitor/TV.
Turn on the power to your connected TVs/monitors. The
LOCAL (orange) LED will illuminate to indicate the local port
has been connected to a display.
14
4/21/2021 4:00:30 PM 4/21/2021 4:00:30 PM