Tripp-Lite B127A-1A1-BHBH Manual Del Propietário página 22

Transceiver Daisy-Chain Installation
(B127A-110-BH only)
8.
9.
10. Connect the external power supply to the B127A-110-BH
11. To add a second B127A-110-BH, repeat steps 8 through
12. Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the
13. Connect a monitor to the HDMI OUTPUT port on the
14. The green LED on the B127A-110-BH will illuminate to
15. Turn on the power to the HDMI source. The orange RJ45
-10-008-933D27-Book.indb 22 -10-008-933D27-Book.indb 22
Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the
B127A-111-BHTH receiver unit to the RJ45 INPUT port on
B127A-110-BH.
Connect a monitor to the HDMI OUTPUT port on the
B127A-110-BH that you just added using a Tripp Lite
P568-Series HDMI Cable.
and plug it into a Tripp Lite surge protector, power
distribution unit (PDU) or uninterruptible power supply
(UPS). The green power LED and the green RJ45 LEDs will
illuminate to indicate the unit is receiving power.
10. To finish your installation with a B127A-110-BH,
proceed to step 12.
last B127A-110-BH to the RJ45 INPUT port.
B127A-110-BH using a Tripp Lite P568-Series HDMI Cable.
indicate the unit is receiving power from the previous
transceiver. The orange LED will illuminate to indicate the
unit is connected to a powered ON remote/repeater unit.
LEDs on the local unit will illuminate to indicate a signal is
being received from the source.
22
4/21/2021 4:00:30 PM 4/21/2021 4:00:30 PM