Sauder 411614 Manual Del Usuario página 14

Step 9 Step
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (L) and lay it over your unit.
Make equal margins along the edges of the BACK (L).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (L) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line
å
up over the SHELF (F), LOWER SHELF (G), and
SMALL UPRIGHT (D).
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
These holes must line up
over the LOWER SHELF (G)
and SMALL UPRIGHT (D).
Page 14
These holes must line
up over the SHELF (F).
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(45 used in this step)
L
411614
Caution
1N
NAIL
www.sauder.com/services