HoMedics enviraScape ETERNAL RAIN Manual De Instrucciones E Información De Garantía página 4

WFL-ETN-A_SP.qxd 2/22/06 3:35 PM
6. Fill base with clean water. Add enough water so that the platform is submerged.
(See embossed line inside the fountain base that represents the water fill line.) (Fig. 6)
Figure 6
7. Attach the A/C adaptor jack to the base power cord. DO NOT plug into outlet at this time.
(Fig. 1)
8. Set the fountain on a level, waterproof surface.
9. Plug the cord into 120V household outlet. The switch located on the power cord controls the
fountain. If pump doesn't operate, rotate in-line switch once to turn "on" and once more to
turn "off". Monthly maintenance will add to your pump's life.
NOTE: Ensure that the electrical cord loops below the electrical outlet to form a 'Drip Loop'
(Fig. 7). This will prevent water from running down the cord into the electrical outlet.
Figure 7
Figure 8
Drip Loop
Front Plate
Page 7
Platform
PVC Tubing
Inserts Here
Back Plate
Impeller Housing
Pump Inlet
Suction Feet
Flow
Control
Lever
6
Maintenance
• To clean the pump:
Unplug from electrical outlet. Remove it from the base of the fountain. Use a small brush or
stream of water to remove any debris (Fig 8).
• To keep water clean:
Periodically change water and clean the product according to the water condition. Keeping
the water clean prevents the water from becoming sticky and forming micro-organisms. We
recommend distilled water to prevent mineral build-up.
• To clean off hard water deposits on the base:
Soak the container in a mixture of vinegar and water to clean and remove any mineral build-up.
• Keeping the water at an optimum level:
Add water periodically to keep water level at an optimum level to avoid shortening the life of
the pump.
NOTE: Never let the pump run dry, as this will shorten the life of the pump.
• Fountain storage
Unplug the fountain from the electrical outlet, empty the water, and store fountain in a dry,
cool place.
Troubleshooting
• If water of rainfall holes fails to flow:
Take off lid and remove cleaning pin. Stick the cleaning pin through holes several times. (Fig. 9)
Then replace lid on top of the fountain.
• If water of rainfall holes fail to flow straight:
Turn off fountain, use absorbent cloth to dry off the top and bottom of rainfall holes. Turn on
fountain. (Repeat if needed until water flows straight.)
• If the pump fails to operate, check the following:
Check the circuit breaker, or try a different outlet to make sure the pump is getting electrical power.
NOTE: Always disconnect from electrical outlet before handling the pump.
• If the pump gurgles, spews, or "burps":
Check the water level to make sure the pump has enough water to function.
• Obtaining a desired water level:
Check the water level daily the first week to measure the rate of evaporation; refill with water
as needed.
Figure 9
Cleaning Pin
7