Adjusting For Fastener Length; Loading The Tool; Driving Screws - Senco DURASPIN DS55 Instrucciones De Empleo

ADJUSTING FOR FASTENER LENGTH

1. Remove battery before adjusting nosepiece for fastener length.
2. Depress the screw selector pin until it is flush with nosepiece and slide the nosepiece to the desired setting by
aligning hatch marks with the silver adjustment pin.
EN
3. Release pin ensuring it is fully engaged in selected nosepiece slot for proper operation.

LOADING THE TOOL

CAUTION
Beware of sharp points on screws. Avoid grabbing this area during loading and operation.
1. Make sure the heads of the screws are resting on top of the plastic collation material.
This will ensure proper strip advancement and prevent jamming.
2. Check for proper fastener length setting (see "Adjusting for Fastener Length" above).
3. Feed the strip into the strip guide up toward the nose of the tool.
4. Feed the strip into the slide body until the first screw is aligned with the bit. The tool will feed all
subsequent screws automatically as the tool is pulled back off the work surface, returning to its relaxed state.
5. To remove the strip, pull it through from the top of the nosepiece.
1

DRIVING SCREWS

1. Whenever possible, hold the tool at a right angle (perpendicular) to the work surface.
2. Pull the trigger to start the motor.
3. Press the nosepiece with constant force against the work surface. Do not remove the tool from the work surface
until the clutch disengages and the bit stops rotating, signalling a fully driven screw.
4. Continue to allow the motor to run. The next screw will be automatically fed into place when the tool is pulled
off the work surface.
TOOL OPERATION
2 3
12
5