Maintenance; Accessories; Technical Specifications - Senco DURASPIN DS55 Instrucciones De Empleo

3. Set the nosepiece on the longest setting possible.
4. Depress the screw selector pin until it is completely depressed. It will be necessary to use a screw or thin object
to depress to this depth.
5. While holding the pin in this position, slide the nosepiece forward and off the slide body.
6. Install the new nosepiece.
7. Replace the nosepiece retention screw ensuring it is seated snug against the slide body.
EN
8. Check for proper fastener length setting (see "Adjusting for Fastener Length" above).

Maintenance

Read section titled "Safety Warnings" before maintaining tool.
1. With battery removed or cord disconnected, make daily inspection to ensure free movement of nosepiece and
trigger. Do not use tool if nosepiece or trigger sticks or binds.
2. Lubrication of the feed system is not necessary. DO NOT OIL.
3. Wipe tool clean daily and inspect for wear, especially the bit and nosepiece. Replace as necessary.
WARNING
Repairs other than those described here should be performed only by trained, qualified personnel.
Contact SENCO for information at +31 320 295 575.

Accessories

SENCO offers a full line of DuraSpin screws and accessories for your SENCO tools, including:
• Bits
• Storage Bag
• Assorted Nosepieces
• Safety Glasses
For more information or a fully illustrated catalogue of Senco accessories, contact your sales representative or call
Senco at +31 320 295 575 www.senco.eu

Technical Specifications

SPECIFICATION
WEIGHT
HEIGHT
LENGTH
WIDTH
FASTENER CAPACITY
FASTENER LENGTH
FASTER RANGE
Table 3 - DS55 Tech Specs
DS55-M1
0.579 KG
140.5mm MAX
279.5mm MAX
372.4mm MAX
50 SCREWS (1 STRIP)
25-55mm
3.5 - 5.5mm
DS55-D1
0.578 KG
140.5mm MAX
273.98mm MAX
372.4 mm MAX
50 SCREWS (1 STRIP)
25-55mm
3.5 - 5.5mm
14
DS55-D2
0.580 KG
140.5mm MAX
262.71mm MAX
372.4mm MAX
50 SCREWS (1 STRIP)
25-55mm
3.5 - 5.5mm