Kohler WELLWORTH K-3422 Instrucciones De Instalación página 5

INSTALL OR REPLACE THE BATTERIES
Insert a screwdriver blade into the seam on top of the
housing assembly. Carefully pry open the battery
compartment latch, and disengage the other side of the
latch from the hinges. Install two D-size batteries in the
compartment. Snap the latch back into place.
ADJUST THE CHAIN ASSEMBLY
The ball chain must be slack to provide proper flush ball
seating. Move the "S" hook up or down on the ball chain
as needed to achieve desired chain slack. Make
additional adjustment by loosening the screws on the
back of the mounting bracket. Raise or lower the mounting
bracket to adjust the chain slack. If you adjust the
mounting bracket, make sure adequate clearance exists
between the housing assembly, flush valve, tank walls,
and tank cover.
TO CONNECT SUPPLY SHUT-OFF VALVE
NOTICE: Read this section carefully before performing
these steps.
To install the supply shut-off valve, refer to the installation
instructions packed with the valve. Carefully bend the
tubing to fit.
Cut the end of the tubing 1/4" (6mm) longer than the
distance between the supply shut-off valve and the supply
shank. Remove any burrs from the inside of the tubing.
Slip the coupling nut, compression nut, and ferrule on the
tubing. Insert the tubing into the supply shut-off valve and
the supply shank, positioning the seal washer (supplied)
or the compression washer (not supplied), as shown.
Handtighten the coupling nut, and then tighten the
compression nut.
A
1007285-2-
Mounting
Bracket
Housing
Assembly
Fill Valve Nut
Supply Shank
Seal Washer
Tubing
Coupling Nut
Compression Nut
Ferrule
5
Latch
Hinges
Fig. #10
"S" Hook
Ball Chain
Fig. #11
Compression Washer
Tubing
Coupling Nut
Compression Nut
Ferrule
Supply Shut-Off Valve
Fig. #12
Kohler Co., Kohler, WI U.S.A.