Bullard CC20E Manual Del Usuario página 12

Sizing and Installing Hard Hat in TICHE Hood
1. Assemble and adjust the standard TGE Bullard hard hat suspensions or the optional TGRE ratchet
suspensions by following the directions on instruction sheet attached to headband on hard hat.
Read all hard hat warning labels and instructions. The following Bullard hard hat models are
approved for use with CC20E Series respirator hoods: 5100E and 5100RE.
2. If desired, install and adjust optional ES42 hard hat chin strap.
3. Before inserting hard hat into hood, remove the adhesive-backed Velcro
Velcro piece that is sewn into the hood.
4. Peel the backing off the Velcro tab and apply it to the inside center rear of the hard hat, about 1/4"
from the edge.
5. Insert hard hat into respirator hood with cap visor facing front of hood. Tuck cap visor on top of
front elastic band sewn into hood (see Figure 7).
6. Loop the Velcro strip sewn inside the hood around the back of the cap and affix it to the corre-
sponding Velcro tab previously installed inside the hard hat in step 4 (see Figure 8).
7. Remove the plastic from lens of respirator hood. If desired, apply optional 20LCL adhesive-backed
lens covers designed to protect the respirator's plastic lens. Apply 2-3 lenses at a time. When a lens
cover becomes soiled, remove it by pulling tab at edge of lens cover to clear your vision.
1. Remove nylon clamp from open end of breathing tube (see Figure 9). Do not remove foam from
inside the breathing tube. The foam helps reduce the noise level of incoming air.
2. Insert breathing tube approximately five inches into hood's air entry sleeve (see Figure 10).
3. Install nylon clamps over air entry sleeve and breathing tube, inserting clamp locks through two
holes in plastic anchorplate that is sewn into hood. Locks should face away from user's neck (see
Figure 11).
4. Engage clamp locks and squeeze together with slip joint pliers until tight.
11
Installing Breathing Tube Assembly
® strip attached to the
Velcro strip
Velcro tab
Front
elastic band
Figure 7
Figure 8
To remove
To tighten
Figure 9
Figure 10
Figure 11
Window
Velcro strip
To tighten