Control Module - Wolf DD30 Guia De Instalacion

Installation
Installation

CONTROL MODULE

1 Use the template provided on the following page to
mark the holes for the mounting screws. Drill one
1 3/4" hole in the center and two 3/8"
(45)
mounting screws.
CAUTION
Verify the scale of the template if not using the
installation guide shipped with the downdraft.
2 Check the countertop thickness to make sure the
threaded studs are long enough to allow the thumbnuts
to fully engage. Thicker countertops may require the
countertop be countersunk from below.
Place the control module on the countertop then
3
secure using the two nuts provided. Once secure, install
the ground wire and nut.
Use the provided cable or a cable designated by the
4
National Electric Code, NFPA/ANSI 70 or local codes.
Connect one end of the control cable to the back side
of the control module and the other to the electrical
connection on the front of downdraft assembly. Ensure
all connections are tight.
5 Use the provided cable clips and ties to attach the
control cable in a secure location away from moving
objects.
GROUND
RJ45
CONNECTOR
Downdraft connection
12 | Wolf Customer Care 800.222.7820
holes for the
(10)
CONTROL MODULE
RJ45
CONNECTOR
NUT
GROUND
COUNTERTOP
Control module connection
WARNING
Do not connect to a telecommunication network.
TOP COVER
Plug the downdraft power cord into a grounded 3-prong
receptacle, then route beneath the appliance and away
from the heat generated by the cooktop. Check the down-
draft operation.
Once operation is verified, raise the downdraft chimney
and install the top trim using the three nuts provided. Verify
the top trim is properly aligned with the side covers. Refer
to the illustration below.
FILTERS
Install the filters. Refer to the illustration below.
TOP COVER
Top cover installation Filter installation