Error Codes - Uline H -7241 Manual Del Usuario

ERROR 20
Calibration out of range
Calibrate seal wire
Turn off and on
ERROR 21
Seal wire
Check connection
Turn off and on
ERROR 22
Temperature not reached
Check seal system
Turn off and on
PAGE 8 OF 27
Calibration out of range.
Calibrate seal wire.
Turn off and on.
Call Uline Customer Service at
1-800-295-5510.
Seal wire.
Check connection.
Turn off and on.
Temperature not reached.
Check seal system.
Turn off and on.

ERROR CODES

ERROR 30
Seal jaw is not closed
Close jaw
Press start to release
ERROR 31
Transport failure
Check film transport
Press start to release
ERROR 32
Transport motor overload
Check film transport
Press start to release
Seal jaw is not closed.
Only possible if a micro switch is
mounted.
Close jaw.
Press start to release.
Transport failure.
Check film transport.
Press start to release.
Remove and reload film from
seal jaw/injector blade.
Transport motor overload.
Check film transport.
Press start to release.
Remove and reload film from
seal jaw/injector blade.
0621 IH-7241