Safety Instructions; Equipment Connection Warnings; Battery Warnings; Quick Installation - Tripp-Lite VS Manual Del Propietário

Important Safety Instructions
SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be followed during the installation, operation and storage of this product.
Failure to heed these warnings will void your warranty.
UPS Location Warnings
• Install your UPS indoors, away from excess moisture or heat, conductive contaminants, dust or direct sunlight.
• For best performance, keep the indoor temperature between 32º F and 104º F (0º C and 40º C).
• Leave adequate space around all sides of the UPS for proper ventilation.
• Do not mount unit with its front or rear panel facing down (at any angle). Mounting in this manner will seriously inhibit the unit's internal
cooling, eventually causing product damage not covered under warranty.
UPS Connection Warnings
• Connect your UPS directly to a properly grounded AC power outlet. Do not plug the UPS into itself; this will damage the UPS.
• Do not modify the UPS's plug, and do not use an adapter that would eliminate the UPS's ground connection.
• Do not use extension cords to connect the UPS to an AC outlet.
• If the UPS receives power from a motor-powered AC generator, the generator must provide clean, filtered, computer-grade output.

Equipment Connection Warnings

• Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the failure of the
life support equipment or to significantly affect its safety or effectiveness is not recommended. Do not use this equipment in the presence
of a flammable anesthetic mixture with air, oxygen or nitrous oxide.
• Do not connect surge suppressors or extension cords to the output of your UPS. This might damage the UPS and will void the surge
suppressor and UPS warranties.

Battery Warnings

• Your UPS does not require routine maintenance. Do not open your UPS for any reason. There are no user-serviceable parts inside.
• Batteries can present a risk of electrical shock and burn from high short-circuit current. Observe proper precautions. Do not dispose of
the batteries in a fire. Do not open the UPS or batteries. Do not short or bridge the battery terminals with any object. There are no user-
serviceable parts inside the UPS.
• Do not attempt to add external batteries to the UPS.

Quick Installation

1 Plug the UPS into a grounded outlet: All three LEDs will illuminate for one second when the UPS performs a self-test.
2 Turn the UPS on: Press the ON/OFF button to turn the UPS on. Note: The UPS will not turn on, even if connected to live utility power,
until it is turned on using the ON/OFF button.
3 Plug your equipment into the UPS: Select outlets (see Basic Operation section) will provide battery backup and surge protection;
connect your computer, monitor and other critical devices here.* Select outlets (see Basic Operation section) will provide surge
protection only; connect your printer and other non-essential devices here.
* Your UPS is designed to support electronic equipment only. You will overload the UPS if the total VA ratings for all the equipment you connect to the Battery Backup Protected/
Surge Protected outlets exceeds the UPS's Output Capacity. To find your equipment's VA ratings, look on their nameplates. If the equipment is listed in amps, multiply the
number of amps by 120 to determine VA. (Example: 1 amp × 120 = 120 VA).
14-09-149-933376.indb 2
2
9/18/2014 1:29:10 PM