Dometic MagicWatch WPS 900F Manual Del Usuario página 20

Setting the system
8.3 Programming the system
I
NOTE
Adapt the programming of the parameters to the type of installation you
have carried out.
You can programme diverse settings.
See fig. h
➤ Start programming as follows:
– Switch on the ignition.
– Release the handbrake.
– Engage reverse gear.
– Press the left button on the control unit for 5 seconds.
The loudspeaker emits a peep tone once, and both LEDs light up.
➤ Set the preferred value (fig. i; chapter "Programming functions" on page 17).
The right button of the remote control is used to set the tens, and the left button
is used to set the units for the preferred value. For example, if you wish to set the
function "24", press the right button twice and the left button four times.
➤ Once you have set the desired value, wait until the loudspeaker beeps in accord-
ance with the value you have set and the respective LED flashes accordingly.
➤ Switch the ignition off.
Configuring the front sensors
The front parking aid is always activated when you:
• Switch on the ignition
• Release the handbrake
• Engage the reverse gear (WPS910 only)
• Briefly press the right button on the loudspeaker (< 5 seconds)
• Press the external button (< 5 seconds)
16
WPS900F/WPS910
EN