Connecting The Parking Aid - Dometic MagicWatch WPS 900F Manual Del Usuario

WPS900F/WPS910
6

Connecting the parking aid

I
NOTE
• On some vehicles, the reversing light only works when the ignition is
switched on. In this case, you must switch on the ignition in order to
identify the positive and earth wires.
• You can set a switch-off time for the front system if you are unable to
provide a speedometer signal for the front sensor control electronics
(neither a digital connection via the CAN bus nor an analogue con-
nection from the speedometer) (see chapter "Programming the sys-
tem" on page 16 and fig. i, parameter 1).
• You can connect the control electronics for the rear sensors directly
to the continuous operating voltage or to the positive cable for the
ignition (fig. d) if you are unable to provide a reversing signal for the
rear sensor control electronics (e.g. +12 V contact voltage from the
reversing light). This is only an option if you use the CAN bus connec-
tion to the control unit, and the vehicle CAN bus provides the revers-
ing signal (see vehicle-specific product overview on the homepage
"http://www.dometic.de/product/waeco-magicwatch-wps-
910").
• A reversing signal is not provided via CAN bus on all vehicles which
allow a CAN bus connection.
EN
Connecting the parking aid
11