Using the parking aid
The front sensors are deactivated when
• the speed of the vehicle is more than 10 km/h
• you press the external button or the right button on the control unit briefly
Press one of the two button for at least 5 s to deactivate the front sensors until the
next time the vehicle is started.
A
NOTICE!
Stop the vehicle immediately and investigate the situation (getting out
if necessary), if the following happens while you are manoeuvring:
the device first indicates an obstacle and the tone sequence speeds up
normally (e.g. from slow to medium) when manoeuvring. The signal
tone suddenly slows down, or no obstacle is indicated at all.
This means that the original obstacle is in the blind spot of the sensors
(construction-related characteristic), and there is still a potential for colli-
sion.
A
NOTICE!
Be especially careful when manoeuvring after the system has been dis-
connected from the front or rear sensors.
The system will indicate this fault by:
• the speaker will emit a double alarm tone.
• the red LED in the control unit and the LED on the external button
flash continuously.
I
NOTE
When the stop zone is reached, the volume of the continuous tone will
fall by about 50 % after a short time.
20
WPS900F/WPS910
EN