Specifications; Water Supply; Before Installation - Toto RENESSE Manual Del Usuario

Specification

Water Supply

Pressure
Supplied Water Temperature
Water Quality
Ambient Temperature
Water Supply Connection
Flow Rate
Depending on the model, some specifications may differ.

Before Installation

▪ Observe all local plumbing codes.
▪ Make sure water supply is shut off.
▪ Read these instructions carefully to ensure proper installation.
▪ Check to make sure you have the following parts indicated below.
● If the water supply pressure is higher than 125psi (0.86MPa), you should buy a
reducing valve to reduce the pressure to the range of 0.2-0.3MPa (0.2-0.3MPa).
To use the faucet comfortably, the recommended pressure is about 30-45 psi
(0.2-0.3MPa).
●To prevent being scalded due to malfunction, the cold water supply pressure must
be higher than the hot water pressure, or you can make them equal. In addition,
if you increase the pressure of the hot water, it still must be lower than that of cold
water supply side.
●To prevent being scalded due to wrong operation, it is recommended the hot water
supply temperature is 140°F (60°C).
●For ease of water flow adjustment and inspection with tools, you should prepare an
extra stop valve.
Please find these in the package.
Holding jig
Installation &
Owner's manual
Minimum pressure
Maximum pressure
Open/close jig
20 psi (0.15MPa)(flowing pressure)
125 psi (0.75MPa)(static)
Less than 185˚F (85˚C)
Water that meet National/Primary drinking water
regulation
34 - 104˚F (2～40˚C)
1/2" NPT
Max. 2.5 gallons per minutes (9.5L/min)
Tools you will need for installation
Pipe Tape Adjustable Wrench Allen Wrech
Check local building
code
2