Hanging The Fan - AirPro Progress Lighting P250060 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Hanging the Fan

REMEMBER to turn off the power. Follow
the steps below to hang your fan properly:
Step 1. Remove the mounting bracket from
the canopy by removing the 1 of 2 screws
from the bottom of the mounting bracket and
loosening the other one a half turn from the
screw head. Next, turn the canopy counter
clockwise to removing the mounting bracket
from the canopy. (Fig. 5)
Step 2. Pass the 120-volt supply wires
through the center hole in the ceiling hanger
bracket as shown in Fig. 6.
Step 3. Secure the mounting bracket to the
ceiling outlet box with the screws and
washers provided with your outlet box.
Step 4. Remove the hanger pin, lock pin from
the ball/downrod assembly, and loosen two
set screws from the top of the motor assembly.
(Fig. 7)
Step 5. Route wires exiting from the top of
the fan motor through the collar cover, canopy
cover, canopy and then through the ball/
downrod. (Fig. 7)
Step 6. Align the holes at the bottom of the downrod
with the holes in the collar on top of the motor
housing (Fig. 7). Carefully insert the hanger pin
through the holes in the collar and downrod. Be
careful not to jam the pin against the wiring inside the
downrod. Insert the locking pin through the hole near
the end of the hanger pin until it snaps into its locked
position, as noted in the circle inset of Fig. 7.
WARNING
FAILURE TO PROPERLY INSTALL
LOCKING PIN AS NOTED IN STEP 6
COULD RESULT IN FAN LOOSENING AND
POSSIBLY FALLING.
Step 7. Tighten two set screws on the motor collar
into the downrod firmly. (Fig. 7)
Step 8. Place the downrod ball into the mounting
bracket socket.
Figure 5
Ceiling
hanger
bracket
120V Wires
Figure 6
Supply wires
Downrod
Canopy
Canopy cover
Collar cover
Collar
Mounting
bracket
Ceiling
canopy
Figure 7
cUL Listed
electrical
box
Washers
Mounting screws
(supplied with
electrical box)
Safety cable
Pin in locked
position
Set screws
Lock pin
4.

Publicidad

Tabla de contenido
loading

Tabla de contenido