Hanging The Fan - AirPro Progress Lighting P250063 Manual De Instalación

Hanging the Fan

REMEMBER to turn off the power. Follow
the steps below to hang your fan properly:
Step 1. Check existing outlet box (not included)
to ensure it is securely fastened to at least two
points in a structural ceiling member and can
support the full weight of the fan.Once verified,
install ceiling bracket assembly to the outlet box
using the screws and washers provided with the
outlet box(Figure 3).
DANGER: A loose outlet box can cause the
fan to wobble and increase the fan's potential to
fall, which could result in serious injury or death.
Step 2. Remove two diagonal mounting screws
on the round holes, keep for later use. And loosen
the other two screws (Figure 4).
Step 3. Hang the motor assembly onto the hook
from the ceiling bracket assembly. This will
allow for hands-free wiring (Figure 5).
Washers
Mounting screws
(supplied with
120V Wires
electrical box)
Figure 3
Figure 4
Washer
Spring
washer
UL Listed
Wood screw
electrical
box
Safety cable
Ceiling
bracket
assembly
Figure 5
Step 4. Drive a wood screw and washers into
the side of the brace that holds the outlet box.
Leave 3mm (1/8") of space between the support
brace and the washer. Insert the safety cable
through the Ceiling bracket assembly and one of
the holes in the outlet box into the ceiling. Adjust
the length of the safety cable to reach the screw
and washers by pulling the extra cable through the
Motor
cable clamp until the overall length is correct, put
assembly
the end of the cable back through the cable clamp,
forming a loop at the end of the cable. Tighten the
cable clamp securely. Now, put the loop in the
end of the safety cable over the wood screw and
under the washer. Tighten the wood screw
securely.(Figure 5)
Ceiling bracket
assembly
Motor assembly
4.