Hex Key (Allen Wrench) - Acuity Brands AEDAN Instrucciones De Instalación

4
INSTALL LUMINAIRE BODY:
4.
4a. Locate the two SET SCREWs on the bottom of the
BACK BOX, and retract them using the HEX KEY
provided so that the screw tips do not protrude into
the BACK BOX. DO NOT retract the screws entirely.
(Figure 4a)
4b. Bring the LUMINAIRE BODY close to the driver on the
wall and engage the Molex connector(s). See section
(on page 13) on properly engaging and disengaging
Molex connectors.
Aedan sconce is being installed, BOTH sets of Molex
connectors need to be connected. Both connectors are equivalent and interchangeable.
4c. Install the LUMINAIRE BODY onto the MOUNTING PLATE by first tilting the top of the fixture towards the wall. Hook the
inside top edge of the BACK BOX onto the top of the MOUNTING PLATE.
4d. Swing the bottom of the luminaire towards the wall while maintaining contact between the inside top edge of the BACK
BOX and the MOUNTING PLATE. Please ensure that all wires are securely inside the MOUNTING PLATE and there are
NO pinched wires.
4e. When the BACK BOX is flush against the wall and the luminaire is hanging on the MOUNTING PLATE, secure the
luminaire by fully engaging the two SET SCREWs on the bottom of the BACK BOX using the HEX KEY provided. Verify
that the luminaire is securely attached by making sure the body does not wiggle.
10
(Figure 4b)
NOTE: If a dual panel
(Figure 4d)
(Figure 4c)
(Figure 4e)