Acuity Brands AEDAN Instrucciones De Instalación página 9

3
MAKE ELECTRICAL CONNECTIONS AND
3.
INSTALL MOUNTING PLATE:
3a. Connect AC line to driver AC input, matching
wire colors: BLACK to BROWN, WHITE to
BLUE. Connect AC ground to case ground and
driver input ground, GREEN to GREEN and
GREEN-YELLOW. Use the (3) large WIRE NUTs
(Figure 3a)
provided.
3b. Connect wall dimmer output to driver dimmer
input, matching wire colors: PURPLE to PURPLE
and GREY to GREY. Use (2) of the small WIRE NUTs provided.
NOTE: If dimming is not desired, fold and cap off the PURPLE and GREY leads on the driver with (2) of the small WIRE
NUTs provided.
Insert wires and WIRE NUTs into the junction box and securely attach the MOUNTING PLATE with driver onto the
3c.
junction box using the (2) 8-32 x 1" mounting fasteners provided as shown.
securely inside the junction box and there are NO pinched wires. NOTE: Compatible mounting fasteners provided by the
installer(s) may also be used.
The MOUNTING PLATE should be level. Use the arrow (pointing UPWARDS) shown on the MOUNTING PLATE as a
3d.
(Figure 3d)
guide.
(Figure 3b.1)
3b.1
If Dimming NOT Desired
(Figure 3b).
(Figure 3c)
Please ensure that all wires are
9