Kohler K-18486 Guía De Instalación Y Cuidado página 9

Arm
O-Rings
Bracket
Small Setscrews
5. Complete the Installation – Freestanding
Remove the protective wrap from the riser tubes.
Slide the tee assembly onto the riser tubes with the setscrew holes
facing down. Do not secure the tee assembly at this time.
Apply lubricant (supplied) to the O-rings on the coupling
assemblies.
Insert the bath filler arms onto the coupling assemblies. Ensure
the arms are flush against the top of the riser tubes.
Secure the arms to the coupling assemblies with the large
setscrews.
Slide the tee assembly up to cover the seam between the arms
and the riser tubes.
Insert the fastener rod to the center of the tee assembly.
Secure the tee assembly with two small setscrews on the
underside of the tee.
Secure the brackets with small setscrews.
Proceed to the "Install the Handshower" section.
Kohler Co.
Large Setscrews
Fastener Rod
Riser Tube
9 1219580-2-A