Troubleshooting; Service Information - Black+Decker Matrix BDCDMT120C Manual De Instrucciones

Problem
• Unit will not start.
• Battery pack will not charge. • Battery pack not inserted into charger. • Insert battery pack into charger until
• Unit shuts off abruptly.
For assistance with your product, visit our website www.blackanddecker.com for the location
of the service center nearest you or call the BLACk+DeCkeR help line at 1-800-544-6986.
The RBRc™ Seal
The RBRC™ (Rechargeable
Battery Recycling Corporation)
Seal on the lithium-ion battery (or
battery pack) indicates that the
costs to recycle the battery (or battery pack)
at the end of its useful life have already been
paid by BLACk+DeCkeR. In some areas, it is
illegal to place spent lithium-ion batteries in the
trash or municipal solid waste stream and the
RBRC program provides an environmentally
conscious alternative.
RBRC in cooperation with BLACk+DeCkeR
and other battery users, has established
programs in the United States and Canada
to facilitate the collection of spent lithium-
ion batteries. Help protect our environment
and conserve natural resources by returning
the tool to an authorized BLACk+DeCkeR
service center for recycling. You may also
contact your local recycling center for
information on where to drop off the spent
battery, or call 1-800-8-BATTeRy.
This Class B digital apparatus complies with
Canadian ICeS-003.
This device complies with part 15 of the FCC
rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
NoTe: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC

TRouBleShooTING

Possible cause
• Battery pack not installed properly.
• Battery pack not charged.
• Attachment is not secured.
• Charger not plugged in.
• Surrounding air temperature
too hot or too cold.
• Battery pack has reached its
maximum thermal limit.
• Out of charge. ( To
maximize the life of the
battery pack it is designed
to shutoff abruptly when
the charge is depleted.)
Possible Solution
• Check battery pack installation.
• Check battery pack charging
requirements.
• Make certain the attachment is fully
pushed into the Power Unit.
LED illuminates.
• Plug charger into a working outlet.
Refer to "Important Charging Notes"
for more details.
• Move charger and battery pack to a
surrounding air temperature of above
40 degrees F (4,5°C) or below 105
degrees F (+40,5°C).
• Allow battery pack to cool down.
• Place on charger and
allow to charge.
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
Changes or modifications to this unit not
expressly approved by the party responsible
for compliance could void the user's authority
to operate the equipment. This Class B digital
apparatus complies with Canadian ICeS-003.

SeRvIce INfoRMATIoN

All BLACk+DeCkeR Service Centers are
staffed with trained personnel to provide
customers with efficient and reliable power
tool service. Whether you need technical
10