Black+Decker Matrix BDCDMT120C Manual De Instrucciones página 9

ToRQue coNTRol - fIGuRe f
This tool is fitted with a torque adjustment
collar (11) to select the operating mode and
to set the torque for tightening screws. Large
screws and hard workpiece materials require
a higher torque setting than small screws and
soft workpiece materials.
• For drilling in wood, metal and plastics, set
the collar to the drilling position symbol
• For screwdriving, set the collar to the
desired setting. If you do not yet know the
appropriate setting, proceed as follows:
• Set the collar to the lowest torque
setting.
• Tighten the first screw.
• If the clutch ratchets before the
desired result is achieved, increase
the collar setting and continue
tightening the screw. Repeat until you
reach the correct setting. Use this
setting for the remaining screws.
f
13
BIT TIP SToRAGe
A magnetic bit storage slot (5) is built into the
area on the top of the tool.
led WoRk lIGhT
When drill is activated by pulling the trigger
switch (1), the integrated LeD work light (4)
will automatically illuminate the work area.
NoTe: The work light is for lighting the
immediate work surface and is not intended to
be used as a flashlight.
dRIllING
• Use sharp drill bits only.
• Support and secure work properly, as
instructed in the Safety Instructions.
• Use appropriate and required safety equipment,
as instructed in the Safety Instructions.
• Secure and maintain work area, as instructed
in the Safety Instructions.
• Run the drill very slowly, using light pressure,
until the hole is started enough to keep the
drill bit from slipping out of it.
• Apply pressure in a straight line with the bit.
Use enough pressure to keep the bit biting
but not so much as to stall the motor or
deflect the bit.
• hold the drill firmly with two hands to
control its twisting action.
• DO NOT CLICk THe TRIGGeR OF A
STALLED DRILL OFF AND ON IN AN
ATTEMPT TO START IT. DAMAGE TO THE
DRILL CAN ReSULT.
• Minimize stalling on breakthrough by reducing
pressure and slowly drilling through the last
part of the hole.
• keep the motor running while pulling the bit out
of a drilled hole. This will help reduce jamming.
• Make sure switch turns drill on and off.
dRIllING IN Wood
Holes in wood can be made with the same
twist drill bits used for metal or with spade
bits. These bits should be sharp and should
be pulled out frequently when drilling to clear
chips from the flutes.
dRIllING IN MeTAl
Use a cutting lubricant when drilling metals.
The exceptions are cast iron and brass which
should be drilled dry. The cutting lubricants that
work best are sulfurized cutting oil or lard oil.
MAINTeNANce
Use only mild soap and damp cloth to clean
the tool. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
IMPoRTANT: To assure product SAFETY
and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual)
should be performed by authorized service
centers or other qualified service personnel,
always using identical replacement parts.
AcceSSoRIeS
WARNING:
The use of any accessory not
recommended for use with this tool could be
hazardous.
Recommended accessories for use with your tool
are available from your local dealer or authorized
service center. If you need assistance regarding
accessories, please call: 1-800-544-6986.
9