Power Supply; Setting Up And Aligning The Scale - Seca 861 Manual Del Usuario

Power supply

The scale is powered by a mains unit or by batteries – ca. 16,000 weighing operations
can be performed with one set of batteries.
– Carefully turn over the scale so that the
base of the scale is accessible.
– Push the battery compartment closure
towards "Battery" and open the cover.
– Connect the cable to the holder and
batteries.
– Place the holder in the battery compart-
ment.
– Close the cover and then turn the scale
back up the right way.
Note: the scale is prepared for use with a seca mains unit which is available as
an accessory.

4. Setting up and aligning the scale

– Place the scale on a level surface.
– Undo the locknuts using the four foot
screws (1).
– Align the scale by undoing the foot
screws. The air bubble in the spirit level
must be right in the centre of the
circle (2).
– Then re-tighten the locknuts (3).
– Ensure that only the feet of the scale are
in contact with the floor. The scale may
not be in contact at any other point.
Important!
The alignment of the base of the scale
must be checked and corrected if nec-
essary every time the location of the
scale is changed.
Model 861
3 .
1 .
2 .
GB
15