Starting Procedure - Maruyama MM92 Manual Del Propietario U Operador

OPERATING INSTRUCTIONS

STARTING PROCEDURE

STEP #1)
Move the "MIST DIAL" to the "0" position.
STEP #2)
Pour chemical into the chemical tank.
STEP #3)
Close the lib tightly.
STEP #4)
Move the "CHOKE LEVER" fully upward to the closed
position. If the engine is already warm, only a partial
or open (no choke) choke setting may be required.
CHOKE
LEVER
PRIMER
BULB
FUEL
RETURN LINE
STEP #5)
Move the "CHOKE LEVER" fully upward to the closed
position. If the engine is already warm, only a partial
or open (no choke) choke setting may be required.
If a MARUYAMA engine fails to start after following the above procedures, contact an authorized MARUYAMA dealer.
STEP #6)
Set the THROTTLE LEVER at 1/2 speed.
STEP #7)
Press down the " LID " and hold the "FRAME" with your right foot
gently.
Pull the "STARTER GRIP" briskly to start the engine.
NOTE: Only short pulls are necessary. Never pull the starter
cord to its fullest extension. Never let go of the starter grip until it
is at the fully returned position.
STARTER
GRIP
STEP #8)
CLOSE
Warming up the engine.
When the engine has started, slowly move the "CHOKE
LEVER" fully downward to the open position.
OPEN
Allow the engine to "WARM-UP" at less than 1/2 speed.
English-6
FULL THROTTLE
THROTTLE
LEVER
IDLE SPEED
CHOKE
LEVER
STOP
BUTTON
LID
FRAME
OPEN