Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions – ILED Retrofit Kit
6.
Mark driver mounting hole(s) 10.5" from center
(Figure 6A). Drill driver mounting hole using 1/8" drill
bit. (Figure 6B.)
Figure 6A.
Figure 6B.
7 .
Install driver(s) using #8 hex washer head gold colored
thread forming screws provided. (Figure 7 .)
Figure 7.
4
COOPER LIGHTING SOLUTIONS
IL519006EN
Installation instructions
8.
Install green ground wire(s) provided. (Figure 8.)
Figure 8.
9.
Connect hot (black) and neutral (white) leads per
application requirement. (Figure 9.)
If second switched hot is present, connect to second
●
●
driver or cap off.
Where applicable, connect dimming circuit.
●
●
Route wiring inside wireway.
●
●
Route supply conducuctors away from heat generating
●
●
components such as LED driver, etc.
Figure 9.
Publicidad
