Molift Quick Raiser 205 Manual De Usuario página 11

6 - Hand control
Connect the hand control to the control panel.
Do not start using lifter before
completing control according to
checklist after assembly.
Checklist after assembly
Use this checklist before use to verify that the lifter
is properly assembled and is safe to opereate.
After assembly, reset emergency
stop by turning it clockwise. Service
light should now be yellow. After
completing this checklist, reset
service indicator as described in the
assembly instructions.
Make sure the leg support and lifting arm are
properly fixed and that there are no loose parts
on the lifter.
Make sure that the lifting column is properly
fixed to the chassis - with both screws
tightened.
Connect lifter to power outlet to make sure
integrated batterycharger works. Charge bat-
tery if necessary.
Check that the lifter has no apparent damage
or other faults.
Perform one lift with load 50-100 kg
NB! Lifter will not operate while charging.
Reset service indicator
If the service LED is yellow, please contact your
Molift service partner
regarding the necessary measures.
Service indicator will start to be yellow again when
12 months has passed and it is time for periodic
inspection.
11
Molift QuickRaiser 205 / www.etac.com