Molift Quick Raiser 205 Manual De Usuario página 8

Molift QuickRaiser 205 / www.etac.com
Before assembly
Locate assembly tools (5mm allen key, and 17mm
spanner)
4
3
1. Battery
2. Leg Support
3. Column in chassis
4. Lifting Arm
5. Mains cable
6. Hand control
Only trained personell shall assem-
ble the lifter
All screws with pre applied
threadlock should only be used
once. Spare part art.no 2920075
Assembly Instructions
6
1
5
2
4x
3x
8
1 - Battery
Push in the emergency stop button before
assembly
Place the column on a horizontal surface.
Make sure the emergency stop is pushed in.
Connect wire from control panel to battery box.
Slide the batterybox in place.
Use the allen key and tighten screw clockwise.
NB! make sure to use the washer.
Make sure the battery is properly
fastened before mounting the
column in the chassis