Molift Quick Raiser 205 Manual De Usuario página 13

Safety devices
Molift Quick Raiser 205 is equipped with several
safety devices, which are intended to prevent
injury to personnel or damage to the equipment in
the case of incorrect use or failure
The lifter has an overload sensor preventing the
lifter to be operated if the load exceeds SWL.
The suspension is hinged to prevent the arm and
suspension from squeezing the user.
Steering handles
Use the steering handles to move the lifter.
Do not push or pull the user,
lifting column or lifting arm.
This may cause stability prob-
lems and lifter may tip over.
The lifter shall only be used for transfer
over short distances. It is not a replacement
for wheelchair or similar.
Brakes
Rear wheels/castors are equipped with kick brakes.
Step on the break to lock brakes. Push up or kick
on top part of the brake to unlock.
Emergency stop / Emergency lowering
Emergency Stop
The emergency stop shuts off the power when
pushed in. Turn clockwise to reset.
Electrical emergency lowering
Use a pen or sharp object to push and hold
button for electrical emergency lowering to lower
suspension. The electrical emergency lowering
function does not work when the emergency stop
is activated.
Only use the electrical emergency
lowering if no other button works.
Manual Emergency lowering
Use the wrench located in the bottom cover to flip
the control panel cover off at the two points.
Push in the emergency stop but-
ton before removing the cover.
Rotating parts represents a squeez-
ing hazard!
Use the 17mm spanner and turn ball screw coun-
ter clockwise until the user is safely lowered. The
manual emergency lowering function should only
be used when the electrical emergency lowering
does not work.
If emergency lowering is used,
mark the lifter "out of order" and
order service!
13
Molift QuickRaiser 205 / www.etac.com