Alarm Mode - NORAUTO 2221275 Manual De Instrucciones

Alarm Mode

Stages Distance
1 > 250cm
2 160-250cm
3 100-150cm
4 70-90cm
5 40-60cm
6 0-30cm
Installation and Test
1. After the installation of sensors. tune the direction to the correct. Arrange the wire in good order.
2. Put the shift lever to the reverse gear. then the reverse lamp is lighted. In this Situation, the display should show the image and there will be a white dot
in middle of the bottom of image. Which indicate the system is under test status.
Test:
a. If the display does not show the rear view, please check that polarity of the power is correct, the calbes are connected correctly, whether the voltage is or
larger than 10.5. Check the plug on the display is well Connected.
b. If distance display in disorder or show 0.0 or give sound continuously. please switch the power off. then select the reverse gear again. If the problems
could not be solved, the control unit could be deemed as a defective and replace a new one.
Awareness Sound Alarm
Safe area silence
Safe area silence
Safe area Bi...Bi...
Alert area Bi...Bi...
Alert area Bi...Bi...
Dangerous area Bi...Bi...
Color
Video
White
1.6-2.5 White
1.0-1.5 White
0.7-0.9 White
0.5-0.6 White
0.0-0.4 White
30
Number
LED/LCD
Green
Green+ yellow
Green+ yellow
Green+ yellow+red
Bar
No bars
1
1-6
7-9
10
10